Kitchen and Dining

Installing Tile Backsplash

Kitchen + Dining

Installing Tile Backsplash

Print Page

BLACK+DECKER B+D Contributor 120 Projects

There are few spaces in your home with as much potential for creativity and visual impact as the space between your kitchen countertop and your cupboards. A well-designed backsplash can transform the ordinary into the extraordinary. Tiles for the backsplash can be attached directly to wallboard or plaster and do not require backerboard. When purchasing the tile, order 10% extra to cover breakage and cutting. Remove the switch and receptacle coverplates and install the box extenders to make up for the extra thickness of the tile.

How to Install Kitchen Tile Backsplash

  1. HI05781301

    Mark a board at least half as long as the backsplash area to match the tile spacing.

  2. HI05781302

    Starting at the midpoint of the installation area, use the story stick to make layout marks along the wall. If an end piece is too small (less than half a tile), adjust the midpoint to give you larger, more attractive end pieces. Use a level to mark this point with a vertical reference line.

  3. HI05781303

    While it may appear straight, your countertop may not be level and therefore is not a reliable reference line. Run a level along the counter to find the lowest point on the countertop. Mark a point two tiles up from the low point and extend a level line across the entire work area.

  4. HI05781305

    Apply mastic adhesive evenly to the area beneath the horizontal reference line using a notched trowel. Comb the adhesive horizontally with the notched edge.

  5. HI05781306

    With a slight twisting motion, press tiles into the adhesive. If the tiles are not self-spacing, use plastic spacers to maintain even grout lines. If the tiles do not hang in place, use masking tape to hold them in place until the adhesive sets.

  6. HI05781307

    Check occasionally to make sure the tiles are level. Continue installing tiles below the first row, trimming tiles that butt against the countertop as needed.

  7. HI05781308

    Mosaic sheets normally do not have bullnose tiles on the edges, so if you don’t wish to see the cut edges of the outer tiles, install a vertical column of edge tiles at the end of the backsplash area.

  8. HI05781309

    When the tiles are in place, make sure they are flat and firmly embedded by laying a beating block against the tile and rapping it lightly with a mallet. Remove the spacers. Allow the mastic to dry for at least 24 hours, or as directed by the manufacturer.

  9. HI05781310

    Spread it over the tiles, keeping the float at a low 30° angle, pressing the grout deep into the joints.

    Note: For grout joints 1⁄8” and smaller, be sure to use a non-sanded grout.

  10. HI05781311

    Wipe off excess grout, holding the float at a right angle to the tile, working diagonally so as not to remove grout from the joints. Clean any remaining grout from the tiles with a damp sponge, working in a circular motion. Rinse the sponge thoroughly and often.

  11. HI05781312

    When the grout has dried to a haze, buff the tile clean with a soft cloth. Apply a bead of caulk between the countertop and the tiles.

View All Kitchen + Dining